|
|
This is an earlier post by Ron. He is creating a new thread each time he
posts!
"When I boot up it boots into the wrong hard drive. I push F2 at boot up
and the drive isnt listed and boots into an older hard drive. I push F11
and it gives me a choice of three hard drives to boot to. I would like
to add the correct drive to F2 at bootup (or auto boot up) so I don't
have to go the F11 route each time. HELP??"
I think when Ron refers to the Power on button he is not refering to the
Start button on the Taskbar. He seems to be attempting to create a dual
or multi boot set up.
~~~~
Gerry
~~~~
FCA
Stourport, England
Enquire, plan and execute
~~~~~~~~~~~~~~~~~~~
Unknown wrote:
> What does the boot menu delay have to do with the start button
> ????????????? "Gerry" <gerry@xxxxxxxxxx> wrote in message
> news:%23VnyHBQ2IHA.2384@xxxxxxxxxxxxxxxxxxxxxxx
>> Ron
>>
>> Change the Boot Menu Delay. Select Start, Run, type "msconfig"
>> without quotes and click on OK. Select the Boot Ini tab and increase
>> the Time Out to required time, click on Apply and OK. Restart your
>> computer to allow the change to take effect. After the computer
>> completes rebooting test to see if it matches your requirements.
>>
>> --
>>
>>
>>
>> Hope this helps.
>>
>> Gerry
>> ~~~~
>> FCA
>> Stourport, England
>> Enquire, plan and execute
>> ~~~~~~~~~~~~~~~~~~~
>>
>> Ron wrote:
>>> When I push the Start Button, the menu comes up but only lasts for
>>> two sec and then disappears. I don't even have time to select a
>>> category and it's gone. How do I delay it?
|
|