[email protected]
[Top] [All Lists]

Re: [Ekiga-list] Newbie configuration experiences...

Subject: Re: [Ekiga-list] Newbie configuration experiences...
From: Terry Barnaby
Date: Sat, 20 Dec 2008 14:02:08 +0000
Alec Leamas wrote:
First of all: I actually got Ekiga 3.0.1 running to the point of a working call to the echo service on my Fedora 10 box which is a Good Thing. You are doing a great job!
However, being a newbie I found it a little harder than it ought to be.
If it's an objective that Ekiga should be easy to setup, here are some
remarks:
Sound device selection.

- There is no support for testing the output devices
  ("Play test sound") for output nor ringing device in
  the device selection menu. I think it should.

- On my Fedora box, some selections makes Ekiga really weird
  e. g., it's possible to connect but not to disconnect.
  The bad thing is that there is no user feedback indicating
  that this is a problem with the sound devices, which makes
  it hard to figure out what's going on.

NAT traversal and router setup:

- My router is a NAT router with the dreaded "Symmetric NAT".
  There *is* an error message when Ekiga is started which
  basically says that I have to configure the router manually.
  The crucial term "Symmetric NAT" is *not* mentioned in this
  message. I finally learned to start ekiga with debug output,
  and grep for 'stun' to reveal this fact. This should really
  easier, the information about "Symmetric NAT" should be
  displayed to the user.

- Once I understood that  my router was doing Symmetric NAT I
  configured port forwarding according to the docs (dynamic,
  triggered ports is not properly handled by my Thomson
  router). I came to a point with working connect/disconnect
  but no sound.

- After some more reading, I understood that the stunnel
  stuff was in the way. So I needed to disable stunnel. There
  are no switches in the UI for this, and even in gconf
  there is no "Use stunnel" option. What I did was to set
  the stunnel host to a non-existing value. This created a
  lot of error messages, and a working Ekiga... This should
  be easier and more straightforward IMHO.

The issue to setup Ekiga with a router doing symmetric NAT couldn't really be out of the box, I understand that. But I still think this process could be easier with better error messages and configuration options. Or, maybe, a "Symmetric NAT" wizard?
Last but not least, I shouldn't have taken the time to write this unless
I really appreciate what you are doing...
--Alec
_______________________________________________
ekiga-list mailing list
[email protected]
http://mail.gnome.org/mailman/listinfo/ekiga-list
I second that.

One thing you may find, if you are using a Thomson ST 585 V6 router as I am, is
that once you have disabled STUN then the ST 585 appears to automatically
open the RTP ports for you. ie you don't need to manually set the router
to port forward them, at least on my setup ...
It seems to also forward them to the correct host (I have a number of systems
behind the ST586).
See my message "No Echo Test response: STUN Problem with Thomson ST585"

Cheers


Terry
_______________________________________________
ekiga-list mailing list
[email protected]
http://mail.gnome.org/mailman/listinfo/ekiga-list

<Prev in Thread] Current Thread [Next in Thread>